# Change the "find radius" parameter in ORS Tools QGIS **URL:** https://ask.openrouteservice.org/t/change-the-find-radius-parameter-in-ors-tools-qgis/1961 **Category:** SDKs **Created:** [July 29, 2020, 7:00pm UTC](https://ask.openrouteservice.org/t/change-the-find-radius-parameter-in-ors-tools-qgis/1961 "2020-07-29T19:00:49Z") **Posts on this page:** 1 **Showing post:** 1
### Author: ![gwfami2](https://ask.openrouteservice.org/letter_avatar_proxy/v4/letter/g/f17d59/32.png) [@gwfami2](https://ask.openrouteservice.org/u/gwfami2) #### Post date: [July 29, 2020, 7:00pm UTC](https://ask.openrouteservice.org/t/change-the-find-radius-parameter-in-ors-tools-qgis/1961/1 "2020-07-29T19:00:49Z")
So once again I don’t know what I’m doing. 🤔 Using the QGIS plugin to get directions from Points 2 Layers, I keep receiving the following error. “Route from Cedar Bluff Reservoir to Okmulgee Creek Site 1 Reservoir OK caused a ApiError: 404 ({“error”:{“code”:2010,“message”:“Could not find point 1: -95.9358120 35.6665870 within a radius of 350.0 meters.”},“info”:{“engine”:{“version”:“6.2.0”,“build\_date”:“2020-07-20T07:00:32Z”},“timestamp”:1596048800254}})” I know what the error means and why it is occuring, but I need to be able to increase the radius to a larger number. I don’t see this ability in parameters portion of the dialog box that comes up in QGIS IRS Tools. How do I set this? Below is the information that shows up first in the log to “build” the request, no radius information or setting can be seen. QGIS version: 3.12.2-București QGIS code revision: 8a1fb33634 Qt version: 5.12.3 GDAL version: 2.4.1 GEOS version: 3.7.2-CAPI-1.11.2 b55d2125 PROJ version: Rel. 5.2.0, September 15th, 2018 Processing algorithm… Algorithm ‘Directions From Points 2 Layers’ starting… Input parameters: { ‘INPUT\_END\_FIELD’ : ‘Lake’, ‘INPUT\_END\_LAYER’ : ‘/Users/xx/Desktop/Lake Distances/NO ZM Lakes.shp|layername=NO ZM Lakes’, ‘INPUT\_MODE’ : 1, ‘INPUT\_PREFERENCE’ : 1, ‘INPUT\_PROFILE’ : 0, ‘INPUT\_PROVIDER’ : 0, ‘INPUT\_START\_FIELD’ : ‘lake’, ‘INPUT\_START\_LAYER’ : ‘/Users/xx/Desktop/Lake Distances/All ZM Lakes/All ZM Lakes No Dups.shp’, ‘OUTPUT’ : ‘TEMPORARY\_OUTPUT’ } --- _[View the full topic](https://ask.openrouteservice.org/t/change-the-find-radius-parameter-in-ors-tools-qgis/1961)._